Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: AIR SUPPLY AND CONNECTIONS
• Do not use oxygen, combustible gases, or bottled gases
as a power source for this tool as the tool may explode,
possibly causing injury.
• Do not use supply sources which can potentially exceed
200 PSI (13.8bar) as tool may burst, possibly causing injury.
• The connector on the tool must not hold pressure
when air supply is disconnected. If a wrong fitting is used,
the tool can remain charged with air after disconnecting
and thus will be able to after the air line is disconnected
possibly causing injury.
• Always disconnect air supply:
1) Before making adjustments;
2) When servicing the tool;
3) When tool is not in use;
4) When moving to a different work area, as accidental
actuation may occur, possibly causing injury.
WARNING: ADDITIONAL SAFETY INSTRUCTIONS FOR
GRINDERS
• Accessories must be rated for at least the speed
recommended on the tool. Wheels and other accessories
running over rated speed can fly apart and cause Injury.
Accessory ratings must be above listed minimum wheel
speed for tool.
• Do not use saw blades or other toothed blades with this tool.
Serious injury may result.
• When starting tool with new or replacement wheel or
other accessory, hold tool in well-protected area and
run for one minute.
• Never start the tool with an operator or others in line with
the wheel or accessory. If the wheel or accessory has
an undetected flaw, it can burst in less than a minute.
• Avoid bouncing the wheel or subjecting it to rough handling
• Direct sparks away from operator, by standards or
flammable materials.
• Disconnect tool from air supply when changing accessories
or when not in use.
• Do not carry tool with throttle depressed. Do not disable Throttle
Safety Lever. Do not tape or lock throttle in run position.
• Use only recommended air tool grinder accessories.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
9
Publicidad
