Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 3 CONNECT ELECTRICAL
CABLES
Verify that power is turned off at the source.
WARNING
If house wiring is not 2-wire with
a ground wire, an electrician will need to convert
existing wiring to meet these specs. When house
wiring is aluminum, be sure to use U.L.-approved
anti-oxidant compound and aluminum-to-copper
connectors.
1. Pull power supply wires through wall of insert
canopy and attach the strain relief. Thread the
house wire through the junction box before the
canopy is inserted in the cabinet cutout.
Wires
2. Attach the white lead of the power supply (A) to the
white lead of the range hood (D) with a wire nut.
Attach the black lead of the power supply (B) to the
black lead of the range hood (C) with a wire nut.
Connect the power supply ground wire lead (E) to
the ground screw (F).
C
Hood
B
Wiring
D
E
A
F
Strain
Relief
49-2000930 Rev. 1
Installation - UVC 9480
Strain
Relief
C
Strain
Relief
D
B
A
Power
Supply
E
F
STEP 4 INSTALL HOOD CANOPY
TO THE CABINET
1. Confirm the damper is in place in the hood
exhaust opening, see previous page for
instructions.
2. Confirm the side panels are mounted (see
previous instructions).
3. Tuck the house wiring out
of the way.
4. Push the hood canopy
straight up through the
cutout opening until the
temporary locking clips
engage. The locking clips
are designed to hold the insert sleeve in place
until it is secured with screws.
NOTE: The locking clips are not designed to support
all of the weight of the insert sleeve. Do not leave
the insert sleeve unattended until screws have been
installed.
5. Fasten the 8 screws (L), 4 on each side, toward
the left and right sides to the side studs of the
cabinet structure. It is recommended to start
with one corner and fasten screws diagonally to
ensure unit flushness with cabinet.
6. Once the hood canopy is in place, seal the duct
to the hood canopy with duct tape (DO NOT USE
SCREWS).
Clip
2x4 Stud
19
Publicidad
