GE UVC9420 Manual Del Propietario E Instalación página 20

STEP 5 INSTALL BLOWER MOTOR ASSEMBLY - UVC-9420 AND 9480
METHOD 1
1. Lift the motor assembly on the insert canopy.
2. Insert the blower motor assembly tabs in the
hood slots and slide it, making sure the 4 tabs are
engaged.
Slots on Hood
20
Installation - UVC 9420 and 9480
Mounting Tabs
3. Tighten the 4 screws (removed earlier) - see
Remove Motor Assembly from Hood Canopy
section. Make sure the blower motor is secured
firmly to the hood canopy.
Screws
4. Reconnect the 4 cables of the motor to the ones
on the hood side and insert them into the protected
area under the control panel.
Connectors on
Hood Side
5. Mount the metal lid and tighten the 3 screws to
secure the lid on the hood body.
Metal Lid
Connectors on
Motor Side
Screws
49-2000930 Rev. 1