Publicidad
Idiomas disponibles
Idiomas disponibles
CONTENTS
(1) GREASE
DAMPER / DUCT
FILTER
(1) PARTS BAG** CONTAINING:
(5) #10 X 5/8"
RD. HD.
MOUNTING
SCREWS
PREPARE THE HOOD
7
Remove all
protective polyfilm
from the hood
(stainless steel
hoods only).
8
Remove the
Aluminum Filter
from the hood by
pulling the tab
down and lifting
filter out.
(4)
9
Remove 8 Screws holding Bottom Pan to hood.
Disconnect Light Harness.
10
Remove parts bag included with the hood. (Parts bag is
inside the hood.)
SCREWS
DAMPER /
DUCT
CONNECTOR
Remove 2 Screws holding Damper / Duct Connector to
11
hood. Remove damper/duct connector from inside the hood.
* FIND INSIDE
OF HOOD
(1) 3¼" X 10"
(1) 7" ROUND
DUCT
CONNECTOR*
CONNECTOR
(1) BULB SUCTION
CUP TOOL
** FIND PARTS BAG
INSIDE OF BOTTOM PANEL.
(1)
PULL
ALUMINUM
(2)
DOWN
LIFT
OUT
(4)
WIRING COVER
SCREW
Remove Wiring Cover from inside of hood Set cover and
12
screw aside.
13
Remove 7" Round Duct Plate from top/back of hood.
FOR NON-DUCTED INSTALLATIONS - Skip to
"INSTALL THE HOOD" .
FILTER
BAFFLE
14
DUCTED INSTALLATION ONLY:
Remove Baffle from Slot above air box.
BAFFLE
DUCTED INSTALLATION ONLY:
15
Rotate Baffle and insert long side into Slot above air
box. Baffle is inserted properly when you feel a positive
stop.
CBD3 SERIES
7" ROUND
DUCT
PLATE
SLOT
SLOT
Page 4
Publicidad
