JVC KD-SR72 Manual De Instrucciones página 4

GETTING STARTED
1
Cancel the demonstration
When you turn on the power (or after you reset the unit), the
display shows: "CANCEL DEMO" "PRESS" "VOLUME KNOB"
1
Press the volume knob.
[YES] is selected for the initial setup.
2
Press the volume knob again.
"DEMO OFF" appears.
2
Set the clock
1 Press and hold .
2
Turn the volume knob to select [CLOCK], then press the knob.
3
Turn the volume knob to select [CLOCK SET], then press the
knob.
4
Turn the volume knob to make the settings, then press the
knob.
Day Hour Minute
5
Turn the volume knob to select [24H/ 12H], then press the
knob.
6
Turn the volume knob to select [12 HOUR] or [24 HOUR], then
press the knob.
7
Press to exit.
To return to the previous setting item, press
4
3
Set the basic settings
1
Press and hold
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step
4
Press
To return to the previous setting item, press
SETTINGS
BEEP
SRC SELECT
AM *
PANDORA *
IHEART *
AUX *
F/W UPDATE
SYSTEM
F/W xxxx
CLOCK
CLOCK SYNC
.
CLOCK DISP
ENGLISH
ESPANOL
* Not displayed when the corresponding source is selected.
.
2
until the desired item is selected or activated.
to exit.
ON: Activates the keypress tone. ; OFF: Deactivates.
ON: Enables AM in source selection. ; OFF: Disables.
ON: Enables PANDORA in source selection. ; OFF: Disables.
ON: Enables IHEARTRADIO in source selection. ; OFF: Disables.
BT ADAPTER: Selects when the KS-BTA100 Bluetooth adapter is connected to the AUX
jack. ( 6) ; ON: Enables AUX in source selection. ; OFF: Disables.
YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not activated).
For details on how to update the firmware, see: <http://www.jvc.net/cs/car/>.
AUTO: The clock time is automatically set using the Clock Time (CT) data in FM Radio
Broadcast Data System signal. ; OFF: Cancels.
ON: The clock time is shown on the display even when the unit is turned off. ;
OFF: Cancels.
Select the display language for menu and music information if applicable.
By default, ENGLISH is selected.
.
Default: XX