Descargar Imprimir esta página

Nilfisk Advance SC4000 Serie Instrucciones De Uso página 18

Publicidad

Idiomas disponibles

Idiomas disponibles

A - ENGLISH
INSTALL THE BRUSHES (CYLINDRICAL SYSTEM)
CAUTION!
Turn the machine OFF at the power switch, before changing the brushes, and before opening any access panels.
1
Make sure the Scrub Deck is in the RAISED position. Make sure the Power Switch (H) is off.
2a
Fixed Side Skirts: See Figure 2-3a. Remove both side blade assemblies. NOTE: The side blade assemblies are held in place by two large
Knobs (BA). Loosen these knobs and then slide the Blade Assemblies (BB) forward and off of the Scrub Deck.
2b
Adjustable Side Skirts: See Figure 2-3b. Unlatch and swing open both Side Blade Assemblies (AA).
Unhook the Latch (AB) on top of the Idler Assemblies (AC) and remove.
3
4
Slide the brush into the housing, lift slightly, push and turn until the tabs on the drive hub seat into the notches in the brush. NOTE: The idler
is designed with a snug fit into the brush to reduce vibration. Re-install the Idler Assemblies (AC) make sure the tabs on the idler are inside of
the weldment (as shown in inset of Figure 2-3). Secure with Latch (AB).
5
Reinstall Blade Assemblies (BB) or close and latch both the Blade Assemblies (AA).
FIGURE 2-3
2-3a
BB
AC
A - 18
INSTRUCTIONS FOR USE
2-3b
AB
BA
Advance SC4000 - 56091272
AB
AA
AC
AC
9/2022

Publicidad

loading

Este manual también es adecuado para:

Advance sc4000 28cAdvance sc4000 28c hpAdvance sc4000 32cAdvance sc4000 32c hpAdvance sc4000 28dAdvance sc4000 28d hp ... Mostrar todo