Publicidad
Idiomas disponibles
Idiomas disponibles
English
Minimum gauge for Cord sets
Total length of Cord in Feet
Volts
120 V
25 (7.6)
240 V
50 (15.2) 100 (30.5) 200 (61.0) 300 (91.4)
Ampere Rating
More
not
Than
More
Than
0
6
18
6
10
18
10
12
16
12
16
14
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
OPM .................... oscillations per
minute
A ......................... amperes
W ........................ watts
or AC ........... alternating current
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. These tools are factory tested; if
this tool does not operate, check power supply.
Intended Use
This pressure washer is intended for cleaning boats, cars,
decks, driveways, grills, house siding, motorcycles, patios,
and outdoor furniture.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
4
(meters)
50 (15.2) 100 (30.5) 150 (45.7)
American Wire gauge
16
16
16
14
16
14
12
Not Recommended
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... avoid staring at
light
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
IPXX .................... IP symbol
Specifications
Maximum Pounds per Square Inch
Rated Gallons per Minute*
Electrical Requirements
Electrical Cord
High Pressure Hose
14
Minimum Amp Source
12
Pressure of Inlet Water*
12
Inlet Water
Soap Consumption Rate
*Water flow and maximum pressure ratings determined in accordance with
CETA CPC-100.
Assemble Frame Handle (Fig. A–C)
Your pressure washer is not fully assembled in the carton.
1. To assemble the frame handle
washer unit
poles
17
so the detent pins snap into position.
Fig. B
Fig. C
7
Assemble Wheels (Fig. D)
Your pressure washer is not fully assembled in the carton.
1. To assemble the wheels
insert an axle pin
nOTE: Follow this process for left and right wheels.
2. With the wheel attached, insert the axle pin
axle bracket
1,900
1.2
120V
35 ft. (10.6 m)
25 ft. (7.6 m)
15A
20-100 PSI
Cold Tap
10% MAX
15
to the pressure
7
, line the upper poles
16
15
20
to the pressure washer unit
21
through the wheel hub
23
and install the retaining pin
~60Hz, 13A
AC
with the lower
16
17
7
,
22
.
21
into the
24
as shown
Publicidad
