Publicidad
Idiomas disponibles
Idiomas disponibles
in Fig. D to the axle pin
nOTE: Follow this process for left and right wheels.
3. Ensure wheels
20
are fully secured to the
axle bracket
23
.
Fig. D
20
21
22
Assemble Crossmember and Spray Handle
Storage Hook (Fig. E)
Your pressure washer is not fully assembled in the carton.
1. To assemble the crossmember
handle
15
, align the four screw tabs
of the crossmember with the with the four slots
in the frame handle and place the crossmember
onto the frame handle
2. Insert the four retaining screws
handle
15
and use a screwdriver to fully tighten the
screws. Ensure the crossmember is fully secured to the
frame handle.
3. To assemble the spray handle storage hook
frame handle
, align the two screw tabs
15
back of the spray handle storage hook
slots
in the frame handle and place the spray handle
31
storage hook
onto the frame handle
29
4. Insert the two retaining screws
handle
15
and use a screwdriver to fully tighten the
screws. Ensure the spray handle storage hook is fully
secured to the frame handle.
Fig. E
29
30
21
until it snaps into place.
7
23
25
to the frame
26
on the back
.
15
28
through the frame
29
to the
on the
30
with the two
29
.
15
28
through the frame
26
27
28
27
31
Assemble High Pressure Hose Storage (Fig. F)
1. To assemble the high pressure hose storage
the detents
member
25
2. After the detents are installed, snap the lower end of the
hose storage into place.
Fig. F
25
24
Attaching Spray Wand (Fig. G)
27
1. To connect the spray wand
25
insert the end of the spray wand inside the spray handle.
2. Press in and turn the spray wand counterclockwise to
lock it into position.
Fig. G
15
Attaching High Pressure Hose (Fig. H-J)
NOTICE: Never pull water supply hose to move
pressure washer. This could damage hose and/or
pump inlet.
To connect the high pressure hose
handle
3
, screw the hose collar
coupler
33
.
To connect the high pressure hose to the pressure washer
unit
7
, screw the hose collar
water outlet
34
nOTE: Uncoil the high pressure hose before installation to
prevent kinks.
nOTE: Avoid cross threading when installing the hose. Cross
threading will cause leaks.
19
in position underneath the cross
as shown in Fig. F.
19
2
to the spray handle
1
to the spray
32
onto the inlet
32
onto the high pressure
.
English
18
, place
18
3
,
3
2
5
Publicidad
