Black and Decker MS2000CY Manual De Instrucciones página 7

fitting sanding sheets - figure D
• Hold the tool with the sanding base (5)
facing upwards.
• Place the sanding sheet (12) onto the
sanding base (5) making sure the holes in
the sheet line up with the holes in the base.
Large detail sanding base
With this sanding base, you can use the tool
as a detail sander or a flush sander.
Attaching the large detail sanding
base - figures E & f
For detail sanding, the pointed end should
face forward as in figure E.
For sanding large areas, the pointed end
should face to the back as in figure F.
• Attach the sanding base as described
above under "Attaching the random orbit
sanding base"
• Press in on the sanding base until you hear
it click into place.
fitting sanding sheets - figure G
• Detach the two diamond-shaped tips (13)
from the sanding sheet (14).
• Hold the tool with the sanding base facing
upwards.
• Place the sanding sheet (14) onto the
sanding base, making sure that the holes in
the sheet line up with the holes in the base.
The diamond-shaped tip (15) can be reversed
and replaced when worn.
• When the front part of the tip is worn,
detach it from the sheet, reverse it and
press it onto the sanding base again.
• When the whole tip (13) is worn, remove it
from the sanding base and fit a new tip (13).
D
5
E
f
14
G
15
13
7
12