Publicidad
Idiomas disponibles
Idiomas disponibles
Tip of the sanding base - figure h
When the sanding tip (14) is worn, it can be
reversed as shown in figure H.
• The tip (14) can be removed and reversed.
finger attachment - figure I
The finger attachment is used for fine detail
sanding.
• Remove the screw (15).
• Remove the sanding holder tip (7) from the
sanding base.
• Fit the finger attachment (8) onto the
sanding base.
• Fit and tighten the screw (15).
• Fit the appropriate sanding sheet (16) onto
the finger attachment.
Operation
Let the tool work at its own pace. Do not overload.
warning: Do not cover the ventilation slots when using the tool. Make sure that the
sanding base is flat on the workpiece.
Switching on and off - figure J
• To switch the tool on, set the on/off switch
(1) to position I.
• To switch the tool off, set the on/off switch
to position O.
h
180
14
I
16
15
8
J
1
8
15
14
7
Publicidad
