Descargar Imprimir esta página

Pioneer SUPER TUNER III D DEH-P4800MP Manual De Instrucciones página 37

Ocultar thumbs Ver también para SUPER TUNER III D DEH-P4800MP:

Publicidad

Idiomas disponibles

Idiomas disponibles

Initial Settings
Adjusting initial settings
1
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Function display
Shows the function status.
1
Press SOURCE and hold until the unit
turns off.
2
Press FUNCTION and hold until the
clock appears in the display.
3
Press FUNCTION to select one of the in-
itial settings.
Press FUNCTION repeatedly to switch be-
tween the following settings:
ClockWARN (warning tone)AUX1 (auxili-
ary input1)AUX2 (auxiliary input2)R-SP
(rear output and subwoofer controller)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down SOURCE until the unit turns off.
Setting the clock
Use these instructions to set the clock.
1
Press FUNCTION to select clock.
Press FUNCTION repeatedly until clock ap-
pears in the display.
All manuals and user guides at all-guides.com
2
Press c or d to select the segment of
the clock display you wish to set.
Pressing c or d will select one segment of the
clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
3
Press a or b to set the clock.
Pressing a will increase the selected hour or
minute. Pressing b will decrease the selected
hour or minute.
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1
Press FUNCTION to select WARN.
Press FUNCTION repeatedly until WARN ap-
pears in the display.
2
Press a or b to turn WARN on or off.
Pressing a or b will turn WARN on or off and
that status will be displayed (e.g.,
WARN :ON).
Switching the auxiliary setting
Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on page 39.
Section
09
37
En

Publicidad

loading