Pioneer SUPER TUNER III D DEH-P4800MP Manual De Instrucciones página 38

Section
09 Initial Settings
1 Press FUNCTION to select AUX1/AUX2.
Press FUNCTION repeatedly until AUX1/
AUX2 appears in the display.
2 Press a or b to turn AUX1/AUX2 on or
off.
Pressing a or b will turn AUX on or off and
that status will be displayed (e.g.,
AUX1 :ON).
Setting the rear output and
subwoofer output
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (R-SP :FUL) or subwoofer
(R-SP :S/W) connection. If you switch the rear
output setting to R-SP :S/W, you can connect
a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
1 Press FUNCTION to select R-SP.
Press FUNCTION repeatedly until R-SP ap-
pears in the display.
2 Press a or b to switch the rear output
setting.
Pressing a or b will switch between
R-SP :FUL (full-range speaker) and R-SP :S/W
(subwoofer) and that status will be displayed.
# When no subwoofer is connected to the rear
output, select R-SP :FUL.
# When a subwoofer is connected to the rear
output, set for subwoofer R-SP :S/W.
# When the rear output setting is R-SP :S/W,
you cannot change the subwoofer controller.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
34).
38
En
All manuals and user guides at all-guides.com
! If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
! Both rear speaker leads outputs and RCA rear
output are switched simultaneously in this
setting.