Milwaukee Heavy-duty BS 100 S Instrucciones De Uso página 2

Introduction
Technical Data
Advice for your
safety
Measured sound
value
Measured
vibration value
Mains
connection
Use
ENGLISH
You have high standards and expect to purchase quality goods – quality offered by
Milwaukee.
We have built a durable and reliable electric power tool for you.
Please read the instructions for use before first operation so you can handle your
power tool effectively and safely.
We are sure that buying an Electric Power Tool from Milwaukee was the right
choice!
Nominal power . . . . . . . . . . . . . . . .
Belt speed no load
Sanding width . . . . . . . . . . . . . . . . . .
Belt length . . . . . . . . . . . . . . . . . . . . .
Sanding surface
Weight . . . . . . . . . . . . . . . . . . . . . . . . .
J Please pay attention to the safety instructions in the attached leaflet!
J Dust that arises when working in wood or using the tool on industrial material can be
dangerous to health. In this case connect the tool to a suction device.
J Appliances used at many different locations including open air must be connected
via a current surge preventing switch.
J Always wear goggles when using the machine. It is recommended to wear gloves,
sturdy non slipping shoes and apron.
J Sawdust and splinters must not be removed while the machine is running.
J Do not pierce the motor housing as this could damage the double insulation (use
adhesives).
J Always disconnect the plug from the socket before carrying out any work on the
machine.
Only plug-in when machine is switched off.
J Keep mains lead clear from working range of the machine. Always lead the cable
away behind you.
J When sanding metal the dust suction facility should not be used, because of the risk
of fire from flying sparks.
Typically the A-weighted noise levels of the tool are:
Sound pressure level = 89 dB (A)
Sound power level = 102 dB (A).
Wear ear protectors! Measured values determined according to EN 50 144.
Typically the hand-arm vibration is below 2.5 m/s
Measured values determined according to EN 50 144.
Connect only to a single-phase AC current supply and only to the mains voltage
specified on the rating plate. Connection to sockets without earth protection is
possible as the appliance features protective insulation to DIN 57 740/ VDE 0740
and CEE 20. Radio suppression complies with the European standard EN 55014.
When fitting the plug, make sure that the brown (live) wire of this appliance is
connected to the plug terminal marked L or coloured red, and the blue (neutral) wire
of this appliance is connected to the plug terminal marked N or coloured black.
Under no circumstances must the wires of this appliance be connected to the earth
terminal of the plug marked either E, with the earth symbol or coloured green or
green/yellow.
The belt sander can be used for sanding wood, plastics and metal.
Do not use this product in another way as stated for normal use.
1
BS 100 S
1150 W
. . . . . . . . . . . . . . 400 m/min
100 mm
610 mm
. . . . . . . . . . . 100 x 160 mm
5,2 kg
BS 100 LE
. . . . . . . . . . . . 1150 W
. . . . . 230–400 m/min
. . . . . . . . . . . . 100 mm
. . . . . . . . . . . . 620 mm
. . . . . . 100 x 160 mm
. . . . . . . . . . . . . 5,2 kg
2
.
BS 100 S, BS 100 LE