Publicidad
Idiomas disponibles
Idiomas disponibles
Installation to Side of Cabinet
1-1
Remove cord covers from wall arm assembly (A) as shown in figure 1.3. Use wall plate as template to mark center of
holes along the vertical line drawn in step 1. Make sure wall plate is level, then drill two 9/32" (7 mm) holes through
cabinet wall where marked.
A
CORD COVERS
fig. 1.3
1-2
Fasten wall arm assembly (A) to side of cabinet using two 1/4-20 flat head screws (B), washers (C), and 1/4-20
nylock nuts (D) as shown in figures 1.4 and 1.5.
Skip to step 2 on page 8.
CABINET
SIDE
WALL
A
Isometric View of
Cabinet Side Wall
All manuals and user guides at all-guides.com
D
C
B
fig. 1.4
VERTICAL LINE
Side View of Cabinet
A
Cutaway View of Cabinet Side Wall
5 of 30
WALL
WALL PLATE
CABINET SIDE WALL
B
fig. 1.5
ISSUED: 06-10-05 SHEET #: 095-9223-8 09-07-06
C D
Publicidad
