Dolmar AL-3630 Manual De Instrucciones página 12

Malfunction status
Motor does not run.
Motor stops running after a little
use.
It does not reach maximum RPM.
The nylon cutting cord does not
feed.
The nylon cutting cord is not cut off
at the correct length.
Cutting head does not rotate:
Stop the tool immediately!
Abnormal vibration:
Stop the tool immediately!
Cutting head and motor cannot
stop:
Remove the battery immediately!
012856
OPTIONAL ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Dolmar tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Dolmar service center.
• Dolmar genuine battery and charger
• Battery converter AA-3618CL
NOTE:
• Some items in the list may be included in the tool
package as standard accessories. They may differ
from country to country.
12
All manuals and user guides at all-guides.com
Cause
Battery cartridge is not installed.
Battery problem (under voltage).
The drive system does not work
correctly.
Rotation is in reverse.
Battery's charge level is low.
Overheating.
Battery is installed improperly.
Battery power is dropping.
The drive system does not work
correctly.
The cord is used up or tangled in the
spool.
The cord cutter on the protector is
damaged or missing.
The cord extends past the protector.
Foreign object such as branch is jammed
between the guard and the nylon cutting
head.
The drive system does not work
correctly.
One nylon cord has been broken and the
head got unbalanced.
The drive system does not work
correctly.
Electric or electronic malfunction.
Noise
The typical A-weighted noise level determined according
to EN786:
Vibration
The vibration emission value determined according to
EN786:
• The declared vibration emission value has been
• The declared vibration emission value may also be
Install the battery cartridge.
Recharge the battery. If recharging is not
effective, replace battery.
Ask your local authorized service center
for repair.
Change the direction of rotation with the
reversing switch.
Recharge the battery. If recharging is not
effective, replace battery.
Stop using of tool to allow it to cool
down.
Install the battery cartridge as described
in this manual.
Recharge the battery. If recharging is not
effective, replace battery.
Ask your local authorized service center
for repair.
Rewind the cord.
Ask your local authorized service center
for repair.
Rewind the cord.
Remove the foreign object.
Ask your local authorized service center
for repair.
Bump the nylon cutting head against the
ground while it is rotating to cause the
cord to feed.
Ask your local authorized service center
for repair.
Remove the battery and ask your local
authorized service center for repair.
Sound pressure level (L
pA
Sound power level (L ): 90 dB (A)
WA
Uncertainty (K): 0.4 dB (A)
Wear ear protection
Vibration emission (a ): 5.5 m/s
h
2
Uncertainty (K): 1.5 m/s
measured in accordance with the standard test method
and may be used for comparing one tool with another.
used in a preliminary assessment of exposure.
Action
ENG905-1
): 82 dB (A)
ENG904-1
2
ENG901-1