Publicidad
Idiomas disponibles
Idiomas disponibles
FEATURES
FRONT VIEW
1
2
3
7
6
4
5
FRONT VIEW
1. Handle Grip
2. Front Panel Release Handle
3. Front Panel
4. Headlight
5. Bumper
6. Clear Dirt Window
7. Hose
BACK VIEW
20
19
18
17
16
15
14
BACK VIEW
8. Upper Hose Wrap
9. Cord Guide
10. Dust Brush
11. Tool Caddy
12. Extension Wand
13. Extension Wand Holder/Hose Clip
14. Wheels
15. Handle Release Pedal
16. On/Off Pedal
17. Lower Cord Wrap
18. Power Cord
19. Crevice Tool
20. Upper Cord Wrap with Quick Cord
Release
5
TOOL REQUIRED: PHILLIPS SCREWDRIVER
BODY ASSEMBLY
1.
HANDLE
BASE
8
9
10
11
3.
12
Slot
Tab
TOOL CADDY, HOSE, AND TOOL ASSEMBLY
13
1.
14
Insert tab on tool caddy into
slot above screw holes on
back of handle.
4.
Hold Extension Wand Holder/Hose Clip in
place while inserting one (1) screw.
Tighten until secure.
HOW TO ASSEMBLE
2.
WARNING:
BEFORE
ASSEMBLING THE BODY
OF THE CLEANER TO
BASE,
MAKE
SURE
POWER CORD IS DOWN
AND OUT OF THE WAY
TO AVOID PINCHING
CORD.
Place the body of the cleaner onto base (Diagram 2).
Push together firmly. Insert longer screw into the
front of body of cleaner to secure (Diagram 2a).
HANDLE ASSEMBLY
4.
Place front panel on
by putting its bottom
tab in the slot on the
vacuum (inset). Close
until it snaps into
place (Diagram 3).
2.
Bring tool caddy down to fit against
handle. Insert two (2) screws to secure
caddy and handle sections. Tighten
screws to secure.
HOSE ASSEMBLY
5.
BACK VIEW
Push curved end of hose
onto the back of unit.
6
2a.
Slide handle down
onto the body of the
cleaner.
3.
Hold lower cord wrap in
place while inserting
one (1) screw. Tighten
until secure.
6.
STORAGE
HOOK
Wrap hose around storage
hook as shown.
Publicidad
