Parkside PBS 600 B1 Instrucciones De Utilización Y De Seguridad página 40

Preparing for use / operation
Vacuum dust extraction
Q
EXPLoSIVE MATERIAL!
If there is an explosive mixture of dust and air you
must use a vacuum device especially intended for
that purpose.
DANGER oF FIRE FRoM FLyING SPARKS!
Do not use any form of dust extraction (dust box
or vacuum extraction device) if you are sanding metal.
DANGER oF FIRE! There is
the danger of fire when working with electrical de-
vices that have a dustbox or can be connected to a
vacuum cleaner. Under certain conditions the wood
dust in the dust collection box (or in the vacuum's
dust bag) may self-ignite, e.g. as a result of flying
sparks generated when abrading metals or metal
objects left in wood. This can happen particularly if
the wood dust is mixed with paint residue or other
chemicals and the abraded particles are hot from
prolonged abrasion. Therefore you must empty the
device's dust collection box and the vacuum clean-
er's dust bag before taking a break or stopping
work and always avoid overheating of the abraded
particles and the device.
Wear a dust mask!
Dust collection with dust collection box
Push the dust collection box
fold on the device side with the adapter connection.
Remove / take out the dust collection box
Pull the dust collection box
Adapter for external dust extraction
(with reducer)
Connecting:
Slide the adapter for external extraction
the adapter connection
use the reducer piece
into the adapter for external vacuum extraction
S lide the hose of a suitable dust extraction de-
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the adapter for external
vacuum extraction
11
if used.
40 GB/MT
into the intended
5
out of the device.
5
into
11
. If it is necessary to
8
, push the reducer piece
12
11
with the reducer piece
12
Removal:
P ull off the dust extraction device hose.
P ull off the adapter for external vacuum extrac-
tion (with the reducer piece
11
operation
Q
5
Switching on and off
Q
When operating the belt sander you can select
between intermittent or continuous operation mode.
To switch on intermittent operation mode:
P ress the on / oFF switch
To switch off intermittent operation mode:
R elease the on / oFF switch
To switch on continuous operation mode:
P ress the on / oFF switch
pressed, then press the locking knob
To switch off continuous operation mode:
P ress and then release the on / oFF switch
Selecting the correct rotational
Q
speed and sanding belt
You can select the belt speed using the belt speed
adjuster wheel
1
The optimum belt speed depends on the workpiece
and the workpiece material. Always confirm the best
speed by carrying out a small test. The following
table lists some recommended values to help you
determine the optimum speed.
Material / type of
work
Coarse finish
(Grit grade)
.
Fine finish (Grit grade) 240
Preselected rotation
speed
,
, if used).
12
4
.
4
.
, and keep it
4
even whilst the sander is running.
Softwood
60
high (5–6)
3
.
4
.