Parker MXP102 Guia Del Usuario página 7

MXP102 - MXP110 User Guide
2.1 Technical Specification
This specification is valid when the equipment is located, installed, operated, and maintained as specified within this user
guide.
Parameter
Minimum Inlet Pressure
Maximum Inlet Pressure
Inlet Temperature
Inlet Connection
Outlet Connection
Model
Dewpoint -40ºC (-40ºF)
cfm
MXP102c 240
MXP103c 360
MXP103 450
MXP104 600
MXP105 750
MXP106 900
MXP107 1050
MXP108 1200
MXP109 -
MXP110 -
Stated flows are for operation at 7 bar g (102 psi g / 0.7 MPag) with reference to 20ºC, 1 bar (a), 0% relative water vapour pressure.
Parameter
Temperature
Humidity
Before continuing with the installation and commissioning of this equipment:
Ensure that it is correctly sized for the inlet pressure, taking into consideration the pressure drop caused by the valves, pipes and
filters within the system. Allowance should be made for purge air loss. The dryer should be typically sized at 1 bar (14 psi/0.1MPa)
below nominal compressor output pressure.
Ensure that it is correctly sized for inlet temperature to meet the dewpoint specified.
-20°C (-4°F), -40°C (-40°F) or -70°C (-100°F).
2.1.1
Flowrate (7 barg / 100 psi g / 0.7 MPa g @ 35ºC / 95ºF)
m 3 / min m 3 / hour
6.80 408
10.19 611
12.75 765
17.00 1020
21.25 1275
25.50 1530
29.75 1785
34.00 2040
- -
- -
Noise
Dimensions
Refer to diagram A1 in Annex A for dimensions and weights
Units
bar g
(psi g / MPa g)
bar g
(psi g / MPa g)
ºC
(ºF)
Inches
Inches
Dewpoint -70ºC (-100ºF)
cfm m 3 / min
168 4.76
252 7.14
315 8.92
420 11.89
525 14.87
630 17.84
735 20.82
840 23.79
945 26.76
1050 29.73
Units
ºC
(ºF)
-
dB(A)
Caution
7
MX102 – MX104
4
(58 / 0.4)
13
(190 / 1.3)
2 – 50
35 - 122
2"
2"
Dewpoint -20ºC (-4ºF)
m 3 / hour cfm
285 264
428 396
535 495
713 660
892 825
1070 990
1248 1155
1427 1320
1605 -
1783 -
MX102 – MX110
2 - 45
35 - 113
50% @ 40ºC
(80% MAX 31ºC)
<80dBA
MX105 – MX110
2 1/2"
2 1/2"
m 3 / min m 3 / hour
7.48 449
11.21 673
14.02 841
18.69 1121
23.36 1402
28.03 1682
32.70 1962
37.38 2243
- -
- -