Publicidad
Idiomas disponibles
Idiomas disponibles
EN
8.1
GENERAL MAINTENANCE
•
Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
•
Tighten correctly all the fasteners and caps.
•
Clean the machine with a dry cloth. Do not use water.
8.2
REPLACE THE BLADE
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade (27) is fully stopped.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting screw (25) and spacer (26) with a
wrench or socket.
7. Remove the blade.
8. Install the new blade. Make sure that the arrows engage
the holes in the blade.
9. Put in the mounting screw and spacer and tighten them.
Recommended tightening torque: 24-27 ft.lbs.
8.2.1
HIGH LIFT BLADE
This mower comes with an extra high lift blade. Normal stock
mower blades perform well on dry, shorter grasses, and are
27
26
25
WARNING
WARNING
NOTE
English
optimized for efficiency, while high lift blades work better in
extreme conditions. The high-lift blade has deeper curves on
the ends, which increase suction to circulate and expel the
clippings. The higher air flow also helps prevent clogging
when mowing tall or wet grass.
8.3
STORE THE MACHINE
•
Clean the machine before storage.
•
Make sure the motor is not hot when you store the
machine.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person at an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
8.4
VERTICAL STORAGE
1. Remove the grass catcher.
12
Publicidad
