Publicidad
Idiomas disponibles
Idiomas disponibles
2. Remove the battery and safety key.
3. Pull through the handle holes to fold away the handles.
4. Lock the handles into position.
5. Stand the machine on end and make sure that the brackets
touch the floor.
9
TROUBLESHOOTING
Problem
Possible cause
The handle is not
The bolts are not
in position.
engaged correctly.
The machine does
The battery ca-
not start.
pacity is low.
The start handle is
defective.
The battery key is
not put in.
The machine cuts
The lawn is rough. Examine the mow-
grass unevenly.
The blade height is
not set correctly.
The machine does
Wet grass clip-
not mulch correct-
pings attach to the
ly.
deck.
The mulch plug is
missing.
The machine is
The grass is too
hard to push.
tall, or the blade
height is too low.
The grass catcher
and the blade
drags in thick
grass.
English
Problem
There is a high vi-
bration in the ma-
chine.
Solution
Adjust the height
of the handle and
make sure that the
bolts and nuts are
aligned correctly.
Charge the battery
pack.
Replace the start
The machine stops
handle.
during mowing.
Put in the battery
key.
ing area.
Move the wheels
to a higher posi-
tion.
Wait until the
grass dries before
mowing.
* If you cannot find the solution to these problems, go to the
service center.
Install the mulch
plug.
10
Increase the blade
height.
Voltage
No load speed
Empty the grass
clippings from the
Deck Size
grass catcher.
Height adjustments
Functions
Weight (without bat-
tery pack)
Battery model
Charger model
13
Possible cause
The blade is un-
balanced and
worn.
The motor shaft is
bent.
The blade height is
too low.
The battery pack is
out of power.
The grass clip-
pings attach to the
deck or the blade.
Operation temper-
ature of the ma-
chine is too high.
TECHNICAL DATA
60 V
2800 RPM / 3200 RPM (Turbo)
21"
1 3/8 - 4" (3.5 - 10.2 cm)
3-in-1Rear bag & Side Discharge
& Mulch
59.5 lbs (27 kg)
LB602/LB6025/LB603/ LB604/
LB605/LB606 and other BAC ser-
ies
CAC801/CH60DP01/
CH60R00/60DPC10A and other
CAC series
EN
Solution
Replace the blade.
1. Stop the mo-
tor.
2. Remove the
safety key and
battery pack.
3. Disconnect the
power source.
4. Inspect for
damage.
5. Repair the ma-
chine before
you start it
again.
Increase the blade
height.
Charge the battery
pack.
Remove the bat-
tery pack and
check the deck.
Cool the machine.
Publicidad
