Black and Decker BDCCS20C Manual De Instrucciones página 7

KICKBACK. Stop saw and allow blade to coast down to a stop. Withdraw from cut and
start a new cut on the line.
• Set depth adjustment of saw such that one tooth of the blade projects below the
workpiece as shown in (figure J).
• Do not back up a rotating blade in the cut. Twisting the saw can cause the back edge of
the blade to dig into the material, climb out of the work and run back toward the operator.
• Avoid cutting nails. Inspect for and remove all nails from lumber before cutting.
IMPOrTanT safeTy InsTrucTIOns fOr BaTTery cHarGers
save THese InsTrucTIOns:
for battery chargers.
• Before using charger, read all instructions and cautionary markings on charger, battery
pack, and product using battery pack.
WarnInG:
cauTIOn:
Black+decker 20V MAX lithium batteries. Other types of batteries may burst
causing personal injury and damage.
cauTIOn:
supply, the charger can be shorted by foreign material. Foreign materials of a
conductive nature such as, but not limited to, steel wool, aluminum foil, or any buildup
of metallic particles should be kept away from charger cavities. Always unplug the
charger from the power supply when there is no battery pack in the cavity. Unplug
charger before attempting to clean.
WarnInG:
• dO nOT attempt to charge the battery pack with any chargers other than the ones
in this manual. The charger and battery pack are specifically designed to work together.
• These chargers are not intended for any uses other than charging designated
Black+decker 20v MaX lithium rechargeable batteries. Any other uses may
result in risk of fire, electric shock or electrocution.
• do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting charger. This will reduce risk of
damage to electric plug and cord.
• Make sure that cord is located so that it will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
• do not use an extension cord unless it is absolutely necessary. Use of improper
extension cord could result in risk of fire, electric shock, or electrocution.
• an extension cord must have adequate wire size (aWG or american Wire Gauge)
for safety. The smaller the gauge number of the wire, the greater the capacity of the
cable, that is 16 gauge has more capacity than 18 gauge. When using more than one
extension to make up the total length, be sure each individual extension contains at
least the minimum wire size.
• do not place any object on top of charger or place the charger on a soft surface
that might block the ventilation slots and result in excessive internal heat. Place
the charger in a position away from any heat source. The charger is ventilated
through slots in the top and the bottom of the housing.
• do not operate charger with damaged cord or plug — have them replaced immediately.
• do not operate charger if it has received a sharp blow, been dropped, or
otherwise damaged in any way. Take it to an authorized service center.
• do not disassemble charger; take it to an authorized service center when service
or repair is required. Incorrect reassembly may result in a risk of electric shock,
electrocution or fire.
• disconnect the charger from the outlet before attempting any cleaning. This will
reduce the risk of electric shock. Removing the battery pack will not reduce this risk.
• never attempt to connect 2 chargers together.
• The charger is designed to operate on standard household electrical power (120
volts). do not attempt to use it on any other voltage.
shock hazard. Do not allow any liquid to get inside charger.
Burn hazard. To reduce the risk of injury, charge only designated
Under certain conditions, with the charger plugged in to the power
save THese InsTrucTIOns
This manual contains important safety instructions
7