Publicidad
Idiomas disponibles
Idiomas disponibles
Permissible accessories
Cutting disc
Roughing disc
Storage and handling of the
recommended accessory tools
■
Grinding tools must be treated with care and
transported carefully.
■
Grinding tools should be stored in such a
way that they are not exposed to mechanical
damage or environmental influences (e.g.
damp).
Working procedures
NOTE
►
Grinding tools should only be used for the
recommended applications. Otherwise, they
can break, be damaged or cause injuries.
Rough grinding
Never use cutting discs
for rough grinding!
■
Move the angle grinder with moderate
pressure back and forth over the workpiece.
■
For soft material, move the roughing disc
at a flat angle over the workpiece; for hard
material at a slightly steeper angle.
PWSA 20-Li E4
125
3
M14
125
6
M14
≥11000
≥72
≥11000
≥72
Abrasive cutting
Never use roughing discs
for cutting!
■
Use only tested fibre-reinforced cutting or
grinding discs that are approved for a
peripheral speed of not less than 80 m/s.
CAUTION!
►
The grinder continues running after being
turned off. Do not try to brake it by applying
lateral counterpressure.
■
Secure the workpiece. Use clamps/a vice to
hold the workpiece firmly in place. This is much
safer than simply holding it in your hand.
■
Always switch off the appliance before
putting it down and wait for the appliance to
come to a complete standstill.
■
Use the appliance only for dry cutting or
sanding.
■
The additional handle
on the appliance for all work.
■
Materials containing asbestos may not be
processed. Asbestos is a known carcinogen.
Two-hole mounting
With
spanner
Two-hole mounting
Without
spanner
must be mounted
GB │ IE
│
8a
8a
9
■
Publicidad
