Descargar Imprimir esta página

Parkside PWSA 20-Li E4 Traduccion Del Manual De Instrucciones Originale página 15

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 140
Tip! This symbol indicates
proper behaviour.
DANGER! ALWAYS GUIDE THE
APPLIANCE THROUGH THE WORK-
PIECE IN REVERSE ROTATION.
In the opposite direction there is a risk of
a kickback. The appliance can be pushed
out of the cut.
Always switch the appliance on before
applying it to the workpiece. After completing
the task, lift the appliance from the workpiece
and then switch it off.
Always hold the appliance firmly with two
hands while working. Ensure that your stance
is secure and stable.
For an optimum grinding effect, move the appli-
ance evenly at an angle of 15° to 30°
(between the grinding disc and workpiece)
backwards and forwards.
When working on angled surfaces, do not
exert great force on the workpiece. If the
rotational speed drops significantly, you must
reduce the pressure exerted to allow safe and
effective working. If the appliance suddenly
brakes completely or jams, it must be switched
off immediately.
Cutting: Work at a moderate feed rate and
do not tilt the cutting disc.
Roughing and cutting discs become very hot
– let them cool down completely before
touching them.
Never use the appliance for purposes other
than the ones for which it was designed.
Always make sure that the appliance is
turned off before inserting the battery into it.
In the event of danger, turn off the appliance
and remove the battery. Ensure that the appli-
ance is easily and quickly accessible in the
event of an emergency.
GB │ IE
10 
Always remove the battery during work
breaks, when adjusting the appliance and
when it is not in use. The appliance must be
kept clean, dry and free of oil and grease at
all times.
Remain alert at all times! Always pay atten-
tion to what you are doing and act with
common sense. Do not use the appliance if
you are distracted or feeling unwell.
WARNING!
Always wear safety goggles.
WARNING!
Always wear a dust mask!
Before use
Charging the battery pack
(see fig. A)
CAUTION!
Always unplug the appliance before you
remove the battery pack
the battery pack to the charger.
NOTE
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should
be checked regularly. The optimum charge
level is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
Connect the battery pack
charger
(see fig. A).
Insert the power plug into the socket. The
control LED
lights up red.
The green LED
indicates that the charging
process is complete and the battery pack
ready.
from or connect
to the high-speed
is
PWSA 20-Li E4

Publicidad

loading