Di4 Vapore Stiro 2600 Manual De Instrucciones página 19

WHEN YOU FINISHED IRONING
Set the temperature dial to the minimum position.
Remove the main plug from the wall socket.
Stand the iron on heel rest.
MANITENCE AND CLEANING
It is recommended to the self-cleaning every two weeks if the water in the area is hard or semi-hard
if frequent use of the device is made
Before cleaning the steam iron ensure it is unplugged from the power supply and has completely
cooled down.
Do not use abrasive cleaners.
To clean exterior surfaces, use a damp soft cloth and wipe dry. Do not use any chemical solvents, as
these will damage the surface.
Cleaning the soleplate; do not use scouring pads or harsh cleaners on the soleplate as these will da-
mage the surface. To remove burnt residue, iron over a damp cloth while iron is still hot. To clean the
soleplate, simply wipe with soft damp cloth and wipe dry.
SELF-CLEANING
Fill the half of the water reservoir.
Set the temperature control to its maximum position.
Insert the main plug into the wall socket.
Allow the iron to heat up until the indicator light goes out.
Unplug the steam iron.
Holding the iron horizontally over the sink and press the button of self-clean, in case if not have this
button change the steam control to the maximum position.
Boiling water and steam will be ejected from the holes in soleplate with impurities washed out Move
the iron over an old (preferably) piece of cloth. This ensures that the soleplate will be dry during sto-
rage.
ANTI-CALC SYSTEM
A special resin filter inside the water reservoir softens the water and prevents scale build-up in the
plate. The resin filter is permanent and does not need replacing.
Please note: Use tap water only. Distilled and/demineralized water makes the "Zero-Calc", anti-calc
system ineffective by altering its physicochemical characteristics.
Do not use chemical additives, scented substances or decalcifies. Failure to comply with the abo-
ve-mentioned regulations leads to the loss of guarantee.
ANTI-DRIP SYSTEM
With the anti-drip system, you can perfectly iron even the most delicate fabrics.
Always iron these fabrics at low temperatures. The plate may cool down to the point where no more
steam comes out, but rather drops of boiling water that can leave marks or stains. In these cases,
the Anti-drip system automatically activates to prevent vaporization, so that you can iron the most
delicate fabrics without risk of spoiling or staining them.
19