Publicidad
Input is via a combo female XLR and 1/4" TRS phone jack with balanced input to the preamp/EQ electronics,
and a level control. A Thru output has an XLR and a TRS 1/4" phone jack connector. These outputs allow linking
of additional speaker systems, or feed of the signal to a powered subwoofer, etc.
The cabinet of the PVXp
in permanent install use. A widely spaced pair of M8 inserts molded-in on the top and the bottom, and a set of
four M8 inserts is available on the top and on the bottom, in the pattern used for the Peavey VM70 mounting
bracket.
This is a total of 12 mounting inserts in all. All of these inserts have retaining hardware on the inside of the
plastic cabinet, providing a more reliable and safe mode of mounting the cabinet.
APPLICATIONS
The Peavey PVXp 10 has a variety of applications such as sound reinforcement, public address, side fill system,
karaoke or musical playback.
A typical signal source for the line-level inputs of the Peavey PVXp 10 would be a sound reinforcement mixing
console (mixer) or the output from a CD player, MP3 player or tape deck. A high-output dynamic microphone
can be connected directly via the XLR input and used as well.
REAR PANEL
1
3
CIRCUIT BREAKER (1)
The unit is AC power line protected from overloads and fault conditions with a 5-amp circuit breaker. This
breaker should not trip unless there is a fault in the amplifier circuitry or an abnormal operating condition,
which causes excessive mains current to flow. If the breaker trips, set the Power switch (3) to OFF, and after
waiting a brief period of time for the breaker to cool, reset the breaker.
If the circuit breaker trips, the center button will pop outward approx. 1/4", and can be reset by pushing upward
and inward. Under normal (not tripped) conditions, the center button is relatively flat.
If the unit continues to trip the breaker, or trips it immediately after being reset, do not keep resetting it, the
system should be taken to a qualified Peavey Service Center for repair.
IEC POWER CORD CONNECTION (2)
This receptacle is for the IEC line cord (supplied) that provides AC power to the unit. It is very important for the
user to ensure that the PVXp 10 has the proper AC line voltage supplied. You can find the proper voltage for
your PVXp 10 printed next to the IEC line (power) cord on the rear panel of the unit.
Please read this guide carefully to ensure your personal safety as well as the safety of your equipment. Never
break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a
ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To
prevent the risk of shock or fire hazard, always be sure that the mixer and all other associated equipment are
properly grounded.
10 speaker system has multiple mounting fly points, providing outstanding versatility
™
2
Publicidad
