Publicidad
ON-OFF SWITCH (3)
This rocker switch supplies AC power to the PVXp
10 when switched to the ON position. The ON position is with
™
the left side of the switch pushed "in" or nearly flush with the rear panel.
REAR PANEL TOP
TOP – OPERATING CONTROLS, INPUTS & OUTPUTS
INPUT (4)
The line-level input is of the medium impedance balanced type. The jack is a combo female XLR and 1/4" TRS
connector.
SPECIAL NOTE! The normal input for line level is the 1/4" TRS jack. It has reduced gain compared to the XLR
input, which has enough gain for a high-output microphone to be used with the Level control. Sensitivity of the
1/4" TRS jack is 0.70 volts for full output, and 0.12 volts for the XLR jack.
LED (5)
Illuminates green when the power switch is On and power is present. It turns red when either of the power
amps engages the DDT
"soft limiting" circuitry.
™
LEVEL (6)
Controls the gain or output level of the input signal. It is used to directly set the system output level for a given
input channel input signal.
CONTOUR (7)
The Contour switch provides a mild boost at the frequency extremes, so that low-level playback can be more
pleasing. Do not use the Contour switch when playing sound at loud levels, as the boost is not needed then.
THRU JACKS (8 & 9)
These jacks are intended for the use of linking multiple PVXp
10 enclosures in a line or to provide a feed to
™
a powered subwoofer, or other electronics that needs to receive a full-range version of the input signal. The
connectors available are a male XLR jack (8), and a 1/4" TRS phone jack (9).
Publicidad
