Sony VPL-FX200U Manual De Instrucciones página 22

Projecting
22
(GB)
When you input the signal from equipment connected to the PC-3000
signal interface switcher (not supplied), set the SWITCHER/VIDEO
MEMORY/INDEX select switch on the Remote Commander to the
SWITCHER position and press the number keys to select the input.
When multiple switchers are connected, press the SW NO/OFF/
GROUP key, then press the number keys to select the input.
Note
Press the SYS SET key when you make the system connections using
the PC-3000 switcher.
Note on the VPL-FX200E model
The optional IFB-X2000E is required for selecting VIDEO.
3
Press the PATTERN key on the Remote Commander or the control
panel to display the HATCH pattern.
4
Press the FOCUS key then the V or v key on the Remote Commander
or the control panel to adjust the focus.
"FOCUS" appears on the screen during adjustment.
5
Press the ZOOM key then the V or v key on the Remote Commander
or the control panel to adjust the picture size.
"ZOOM" appears on the screen during adjustment.
Note
If the optional VPLL-2075, VPLL-2014 or VPLL-2009 lens is
installed, you cannot adjust the zoom.
6
Press the FOCUS and arrow keys on the Remote Commander or the
control panel to adjust the focus again.
"FOCUS" appears on the screen during adjustment.