Publicidad
Idiomas disponibles
Idiomas disponibles
Connection Examples
Connecting the Switcher
Use the optional PC-3000 Signal Interface Switcher
for connecting various video equipment. The input can
be selected by pressing the SWITCHER/VIDEO
MEMORY/INDEX keys on the Remote Commander.
For selecting the input from the switcher, see page 15 (GB).
Notes
• When you select the input from the switcher, be sure
to set the SWITCHER/VIDEO MEMORY/INDEX
select switch to the SWITCHER position.
Rear
to INPUT A
SIC-10 connecting cable
(5BNC ˜ 5BNC)
(not supplied)
Computer, etc.
34
(GB)
INPUT C
INPUT B
INPUT A
VIDEO
+
–
AUDIO OUT
REMOTE
CONTROL S
TRIG
DEVICE INDEX
0
to PJ COM IN
to OUTPUT
PC-3000 switcher
• When connecting the switcher, use the wired Remote
Commander. If you use the wireless Remote
Commander, activate the remote control detector on
only one unit of the equipment connected through the
PJ COM connector. For the other equipment, set
SIRCS RECEIVER in the SET SETTING menu to
OFF to deactivate the remote control detectors.
For details, see page 31 (GB).
• After all the connections are complete, attach the
terminator (supplied) to the PJ COM connector on
both the projector and switcher to which nothing is
connected.
Device index number: 01
to AC IN
RCC-5G/10G/30G
connecting cable
(not supplied)
to PJ COM OUT
Attach the
OUT PUT
RS-232C/422A
terminator
SW NO
RS-232C
REMOTE
RS-422A
RS-485 IN
(supplied with
RS-485 OUT
the PC-3000).
VCR, etc.
AC power cord
(supplied)
to the wall outlet
Attach the
supplied
terminator.
:
Signal flow
Publicidad
