Publicidad
Idiomas disponibles
Idiomas disponibles
Setting the Index Numbers
To select the projector by designating the index numbers
PC-3000
Signal flow
PC-3000
Signal flow
Projector A
Signal flow
Projector B
Group index 01
38
(GB)
When the switchers and projectors are connected as illustrated, select the
desired projector by pressing the keys on the Remote Commander as
shown below.
PJ COM
Number 2 switcher
PJ COM
Number 1 switcher
PJ COM
Device index 01
PJ COM
Device index 02
Example:
To select all the projectors
GROUP n ALL n ENTER n ALL n ENTER
Projectors A, B, C and D are selected.
To select projectors with device index 01 from all the groups
GROUP n ALL n ENTER n 1 n ENTER
Projectors A and C are selected.
To select a projector with device index 01 from group index 02
GROUP n 2 n ENTER n 1 n ENTER
Projector C is selected.
To select all the projectors from group index 02
GROUP n 2 n ENTER n ALL n ENTER
Projectors C and D are selected.
Notes
• Set the group index and device index numbers correctly. If more than two
projectors are set to the same group index and device index numbers, an
error message will be displayed when the SYS SET key is pressed.
• If the group index is a tens digit number, press the GROUP key before
each press of the number key.
Example:
To select a projector with device index 13 of group index 12
GROUP n 1 n GROUP n 2 n ENTER n 1 n 3 n ENTER
Number 2 switcher
PC-3000
PJ COM
Signal flow
Number 1 switcher
PC-3000
Signal flow
PJ COM
Projector C
Device index 01
Signal flow
PJ COM
Projector D
Device index 02
Group index 02
Publicidad
