Bresser National Geographic 9070100 Instrucciones De Uso página 28

Main unit channel setting
1. The main unit can be connected with a maximum of up to 3 transmit-
ters.
2. Press the CHANNEL button to switch between the displays of each
channel. The main unit will display the information of the correspond-
ing transmitter. When the symbol
mation the automatic display rotation is activated. The display changes
between the information of the connected remote sensors every 10 sec-
onds.
NOTE!
The function to change the channels by pressing the CH-button can be
used only if more than one remote sensor is connected with the main
unit. Otherwise this function is disabled.
Automatic time setting
1. After the batteries are installed. The clock will automatically search for
the radio signal. It takes about 3-5 minutes to finish this process.
2. If the radio signal is received, the date and time will be set automatical-
ly and the radio control signal icon
If the clock fails to receive the time signal, go ahead with the following
steps:
28
is displayed near the channel infor-
turns on.
1. Press UP and DOWN button at the same time for approx. 3 seconds to
initialize radio signal reception manually.
2. If the time signal receiving fails again, the time can be set manually.
Manual time setting and user-defined settings
1. In normal display mode, press and hold the MODE button for approx 2
seconds to enter settings mode. '24Hr' will flash.
2. Press the UP or DOWN button to change the value.
3. Press the MODE button to confirm and go to the next value to be
changed.
4. The setting order is 24/12 hour mode >> °C/°F >> hPa/inHg >> time
zone (-2 to +2 hours) >> hours >> minutes >> year >> month >> date >>
language (GE = german / EN = english / IT = italian / FR = french / SP =
spanisch) >> save and exit.
5. If there is no operation for 20 seconds, the existing setting will be
saved and the device returns to normal display mode. You can also press
the MODE button again to confirm and exit.
NOTE!
Independent from the time setting method we recommend to select the
city next to you manually (see "Set city").