Adjusting Control Handle Height; Machine Operation; Pre--Operation Checks; Operating Machine - Tennant 5100 Manual De Operador

FIG. 18
c. The ES light will glow when the ES pump is
recycling.

ADJUSTING CONTROL HANDLE HEIGHT

The control handle has three height settings to
accommodate a comfortable operating height.
1. Locate two control handle height adjustments
knobs on handle (Figure 19).
2. Pull both knobs and raise or lower handle, release
knobs to lock (Figure 19).
FIG. 19

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
PRE- -OPERATION CHECKS
Sweep and dust mop floor to remove particles and
S
other debris.
Check battery meter charge level to ensure
S
batteries are fully charged (See BATTERY
CHARGING).
Check condition of pad or brush.
S
Speed Scrub 1701 Plus (06- -05)
Home Find... Go To..
Check condition of squeegee blades.
S

OPERATING MACHINE

1. Release brush lift pedal from transport position by
stepping down on scrub head release pedal
(Figure 20).
FIG. 20
2. Lower squeegee assembly by moving squeegee
lift knob to the right (Figure 21).
FIG. 21
FIG. 22
NOTE: The solution flow and brush will not start until
brush triggers are pulled.
4. Pull brush triggers and begin walking with
machine. The brush will propel the machine
forward allowing little effort maneuvering the
machine (Figure 23).
OPERATION
11