Installing Pad Driver Or Brush - Tennant 5100 Manual De Operador

FIG. 8
4. Tighten thumb knobs securely.
5. Connect vacuum hose from machine to squeegee
assembly (Figure 9).
FIG. 9

INSTALLING PAD DRIVER OR BRUSH

1. Select a recommended pad or brush that best
meets your cleaning needs.
NOTE: Consult an authorized distributor for
pad/brush recommendations.
2. Attach pad to pad driver before mounting driver to
motor hub. Secure pad with plastic centerlock ring
(Figure 10).
FIG. 10
Speed Scrub 1701 Plus (02- -04)
Home Find... Go To..
3. Turn key switch on (Figure 11).
FIG. 11
4. Place the pad driver/brush on the floor in front of
the scrub head (Figure 12).
FIG. 12
5. Tilt the machine back on it's rear wheels and
center the scrub head down over the pad
driver/brush (Figure 12).
6. IMPORTANT STEP: Release the brush lift pedal
from the transport position (Figure 13). Align the
motor hub down inside the pad driver/brush.
FIG. 13
7. Pull the triggers to engage the pad driver/brush.
Make sure the front wheel is in the UP position
(Figure 14).
NOTE: When a pad driver/brush is not installed, make
sure to keep the machine in transport position to
prevent skirt damage.
OPERATION
9