Adjusting Control Handle Height; Machine Operation; Pre--Operation Checks; Scrubbing With Machine - Tennant 5100 Manual Del Operador

ADJUSTING CONTROL HANDLE HEIGHT

The control handle has three height settings to
accommodate a comfortable operating height.
1. Locate two control handle height adjustments
knobs on handle (Figure 15).
2. Pull both knobs and raise or lower handle, release
knobs to lock.
FIG. 15

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
PRE- -OPERATION CHECKS
Sweep and dust mop floor to remove particles and
S
other debris.
Check power cord for damage. Replace
S
immediately if damaged.
Check condition of pad or brush.
S
Check condition of squeegee blades.
S
Tennant 5100 (05- -05)
Home Find... Go To..

SCRUBBING WITH MACHINE

1. Release brush lift pedal from transport position by
stepping down on scrub head release pedal
(Figure 16).
FIG. 16
2. Lower squeegee assembly by moving squeegee
lift knob to the right (Figure 17).
FIG. 17
3. Turn on main power, vacuum and solution
switches (Figure 18).
FIG. 18
NOTE: The solution flow and brush will not start until
brush triggers are pulled.
OPERATION
9