Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Problem
Possible Cause
The ma-
The guard is not
chine stops
attached to the ma-
when you
chine.
cutting.
Heavy cutting line
is used.
The grass winds
around the motor
shaft or the trim-
mer head.
The motor is over-
loaded.
The battery pack
or machine is too
hot.
The battery pack is
disconnected from
the tool.
The battery pack is
depleted.
The line
Lines are welded
does not ad-
to themselves.
vance.
Not enough line
on the spool.
Lines are worn
and too short.
Lines are tangled
on the spool.
English
Solution
Remove the battery pack
and attach the guard to
the machine.
Use only with the nylon
cutting line of 1.65 mm
diameter.
1. Stop the machine.
2. Remove the battery
pack.
3. Remove the grass from
the motor shaft and trim-
mer head.
1. Remove the trimmer
head from the grass.
2. The motor will recover
to work as soon as the
load is removed.
3. When you cut, move
the trimmer head in and
out of the grass to be cut
and remove no more than
20 cm in pass.
1. Cool the battery pack
until its function returns
to normal.
2. Cool the machine for
approximately 10 mi-
nutes.
Install the battery pack
again.
Charge the battery pack.
Lubricate with silicone
spray.
Install more line.
Advance the cutting line.
1. Remove the lines from
the spool.
2. Wind the lines.
Problem
Possible Cause
The line
The machine is
keeps
used incorrectly.
breaking.
The grass
Cut tall grass at
winds
ground level.
around the
trimmer
head and
motor hous-
ing.
The line
The cut-off blade
does not cut
becomes dull.
well.
Vibration
The line is worn
increases
down at one side
obviously.
and not advanced
in time.
9
WARRANTY
(The full warranty terms and conditions can be found on
Greenworks website https://www.greenworkstools.eu)
The Greenworks warranty is 3 years on the product, and 2
years on batteries (consumer/private usage) from the date of
purchase. This warranty covers manufacturing faults. A faulty
product under warranty might be either repaired or replaced.
A unit that has been misused or used in other ways then
described in the owner's manual might be rejected for
warranty. Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not affected
by any additional warranty offered by a dealer or retailer.
A faulty product must be returned to the point of purchase in
order to claim for warranty, together with the proof of
purchase (receipt).
10
EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
Name:
GLOBGRO AB
Globe Group Europe
Address:
Riggaregatan 53 211 13 Malmö, Sweden
Name and address of the person authorised to compile the
technical file:
Name:
Micael Johansson
8
Solution
1. Cut with the tip of the
line, avoid stones, walls
and other hard objects.
2. Advance the cutting
line regularly to keep full
cutting width.
1. Cut tall grass from the
top down.
2. Remove no more than
20 cm in each pass to
prevent wrapping.
Sharpen the cut-off blade
with a file or replace it.
Make sure that the line on
both sides is equal. Ad-
vance the line.
Publicidad
