Publicidad
Idiomas disponibles
Idiomas disponibles
English
1. To drive the nail deeper, rotate the depth adjustment
wheel to the right. Setting 5 is the deepest.
2. To drive a nail shallower, rotate the depth adjustment
wheel to the left. Setting 1 is the shallowest.
Test drive another fastener and check depth. Repeat as
necessary to achieve desired results.
Fig. H
5
Stall Release (Fig. I)
If the nailer is used in harder wood where all available
energy in the motor is used to drive a fastener, the tool
may stall. The driver blade will not complete the drive cycle
and the jam/stall indicator will flash. Rotate the stall release
lever
on the tool and the mechanism will release.
12
nOTE: The tool will disable itself and not reset until the
battery pack has been removed and reinserted. If the driver
blade does not automatically return to the home position,
proceed to Clearing a Jammed Nail. If the unit continues
to stall please review the material and fastener length to be
sure that it is not too rigorous an application.
Fig. I
12
Clearing a Jammed Nail (Fig. A, E–G)
WARNING: To reduce the risk of serious personal
injury, disconnect battery pack from tool before
making any adjustments, changing accessories,
servicing, or moving the tool. Such preventative
safety measures reduce the risk of starting the
tool accidentally.
If a nail becomes jammed in the nosepiece, keep the tool
pointed away from you and follow these instructions
to clear:
1. Remove battery pack from tool and engage trigger
lock-off.
2. Push the door latch
11
to open the nail door
12
3. Open the canister cover
4. Remove the jammed nail.
5. Correct any deformation that may have occurred to the
nail coil.
nOTE: Should nails jam frequently or the driver blade
continually fail to reset, have tool serviced by an authorized
D
WALT service center.
e
Cold Weather Operation
When operating tools at temperatures below freezing:
•
Keep tool as warm as possible prior to use.
•
Actuate the tool 10 or 15 times into scrap lumber
before using.
Hot Weather Operation
Tool should operate normally. However, keep tool out of
direct sunlight as excessive heat can deteriorate bumpers
and other rubber parts resulting in increased maintenance.
Belt Hook (Fig. A)
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
WARNING: To reduce the risk of serious personal
injury, ONLY use the tool's belt hook to hang
the tool from a work belt. DO NOT use the belt
hook for tethering or securing the tool to a person or
object during use. DO NOT suspend tool overhead or
suspend objects from the belt hook.
WARNING: To reduce the risk of serious personal
injury, ensure the screw holding the belt hook
is secure.
iMPORTAnT: When attaching or replacing the belt hook
use only the screw that is provided. Be sure to securely
tighten the screw.
The belt hook can be be attached to either side of the tool
using only the screw provided, to accommodate left- or
right- handed users. If the hook is not desired at all, it can be
removed from the tool.
To move the belt hook, remove the screw that holds the
belt hook in place then reassemble on the opposite side. Be
sure to securely tighten the screw.
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
8
6
.
9
,
Publicidad
