Bosch NIT8668UC Manual Del Usuario página 11

Residual heat indicator
The cooktop has a residual heat indicator for each
element. This indicates that an element is still hot. Do not
touch an element while the residual heat indicator is lit
up.
The following indicators are shown depending on the
amount of residual heat:
Display • : High temperature
▯
Display : Low temperature
œ
▯
Operation
Main power switch
Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the On/Off touch key until the indicator above the
main switch and the temperature level indicators
to the heating elements turn on.
Turning the cooktop off
Touch the On/Off touch key. The __ indicator goes out.
The cooktop is switched off. The residual heat indicators
will remain on until the elements have cooled off
sufficiently.
Note: The cooktop switches off automatically when all
the elements have been switched off for more than 20
seconds.
The residual heat indicator remains lit until the elements
have cooled down sufficiently.
the corresponding element symbol.
next
‹
/ is displayed next to
• œ
If you remove the cookware from the element during
cooking, the residual heat indicator and the selected
heat setting will flash alternately.
When the element is switched off, the residual heat
indicator will light up. Even after the cooktop has been
switched off, the residual heat indicator will stay lit for as
long as the element is still warm.
Setting the cooktop
This section will show you how to set the elements. The
table contains details on the heat settings for a variety of
dishes.
Setting the element
Select the desired heat level using the number keys
1 to 9.
Heat level 1 = minimum power
Heat level 9 = maximum power
Each heat setting has an intermediate level. This level is
indicated by . in the element display and is set by
touching the symbols between the number keys.
û
Selecting the heat level
The cooktop must be turned on.
Select the desired element with by touching the
1.
symbol on the control panel. In the element display
and the __ indicator light up.
Within the following 10 seconds, set the desired power
2.
level using the number keys.
To change the power level, select the element and set
3.
the desired power level using the number keys. To set
an intermediate level touch the
number keys.
$
‹
symbols between the
û
11