Descargar Imprimir esta página

Orbegozo CR 5031 CR Manual De Instrucciones página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

CR 5031 CR 5032
: "Cool air". Only the fan is switched on
: "Warm air for gradual heating-up. ECO position (1000 W): the fan and one of the heating elements are
switched on.
: "Hot air" for quick heating-up. Full power (2000 W): the fan and the two heating elements are
switched on.
Thermostat knob (A):
With the thermostat knob you can set a constant room temperature. When the selector switch is set to
position
or position
below the set temperature.
As soon as the set temperature falls is reached, the switch will turn off.
Rotate the knob clockwise to obtain a higher temperature setting or anti-clockwise for a lower temperature
setting.
You may adjust the thermostat during use.
Oscillation for model CR 5032 (C)
With the rocker switch you can switch on or off the oscillation of the fan heater. The oscillation function can
be operated to every function separately.
OVERHEATING SAFETY DEVICE
To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the power
as soon as the heating elements become too hot.
MAINTENANCE
- Before undertaking any maintenance operation, disconnect the appliance from the power supply.
- This appliance does not require any particular maintenance. For cleaning it is recommended to use a soft
moist rag and neutral detergent. Do not use an abrasive cloth or devices which could affect the outward
appearance of the appliance. Check that the parts exposed to the heat rays and the ventilation are free of
dust and dirt.
- In case of breakdown and/or poor function of the appliance, disconnect the appliance from the power
supply and contact an authorized service center. Always request the use of original spare p arts.
The non-observation of these instructions can compromise the safety of the appliance and render guaranty
invalid.
TECHNICAL CHARACTERISTICS
Model: CR 5031 – CR 5032
Voltage: 230 V
Power: Maximum 2000 W (1000 W – 2000 W)
Tension: 50 Hz.
the heater will automatically switch on as soon as the room temperature falls
13

Publicidad

loading

Este manual también es adecuado para:

Cr 5032