Press briefly to enable/disable the Delay,
automatic switch-off of the Motor and Lighting
system with a 30 minute delay. It can also be
deactivated by pressing A.
Press and hold the button for approx. 2 sec. to
D
Activate/Deactivate the motor in 24H Air Circulation
mode, a speed that allows ducting for 10 minutes
every hour, for a 24 hour cycle. It can also be
deactivated by pressing A.
Press button E briefly to Activate/Deactivate
automatic ODOUR SENSOR mode, which
changes the speed of the motor according to the
odours detected.
Press and hold the button for 2 sec. to change the
E
type of hob from GAS to Electric and vice versa.
By default it is set to a GAS hob.
This operation forms part of the ODOUR SENSOR
set-up, which:
• For the Gas hob, set-up takes 1 min.
• For the Electric hob, set-up takes approximately
15 min.
1° Press briefly a second time: light at maximum
intensity.
2° Press briefly a first time: turns the light on at
medium intensity.
3° Press briefly a third time: light turns off.
F
Press and hold the button for approximately 2
seconds, when the light is on, to change the
light colour temperature, switching from a warm
light (approximately 2700K) to a neutral light
(approximately 4000K).
5. LIGHTING
• For replacement contact technical support
("To purchase contact technical support").
12
On/Off + " animation " on the display.
Flashing + " animation " on the display.
- Disables all functions except the lights.
- Button E starts to flash
- The LED lights up at full intensity.
- The LED lights up at medium intensity.
- The LED goes out.