Safety guidelines for battery chargers
This appliance may be used by chil-
■
dren aged 8 years and above and
by persons with limited physical,
sensory or mental capabilities or
lack of experience and knowledge,
provided that they are under super-
vision or have been told how to use
the appliance safely and are aware
of the potential risks . Do not allow
children to use the appliance as a
toy . Cleaning and user maintenance
tasks may not be carried out by
children unless they are supervised .
To avoid potential risks, damaged
■
mains cables should be replaced
by the manufacturer, their customer
service department or a similarly
qualified person .
The charger is suitable for indoor use
only .
WARNING!
■
To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or a
similarly qualified person .
ATTENTION!
Hot surface .
Risk of burns .
■
18
│
GB │ IE
Before use
Charging the battery pack (see fig . A)
CAUTION!
►
Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger .
■
Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C .
♦
Connect the battery pack
charger
(see Fig . A) .
♦
Insert the power plug into the socket . The control
LED
lights up red .
♦
The green control LED
charging process is complete and the battery
pack
is ready .
CAUTION!
♦
If the red control LED
that the battery pack
cannot be charged .
♦
If the red and green control LEDs
flash, this means that the battery pack
defective .
♦
Insert the battery pack
ance .
♦
Switch off the charger for at least 15 minutes
between successive charging sessions . Also
disconnect the power plug from the mains
power socket .
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦
Push the rotation direction switch
middle position (lock) . Allow the battery pack
to click into the handle .
Removing the battery pack:
♦
Press the release button
battery pack .
to the rapid battery
indicates that the
flashes, this means
has overheated and
both
is
back into the appli-
into the
and remove the
PDSSA 20-Li A1