Descargar Imprimir esta página

JENN-AIR 720-0709B LP Instrucciones De Instalación Y Manual De Uso Y Cuidado página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Remove the access cover at the back of the grill by removing
the 6 screws at the back of firebox.
A. Access cover
3. Using a Phillips screwdriver, remove the screw holding the
spider guard to the burner.
4. Use 24 mm wrench to remove the orifice nut.
A
A. Orifice nut
5. Take out the orifice support, and then use a 6 mm socket and
wrench or 6 mm nut driver to remove the LP orifice at the end
of the supply pipe. Replace with Natural gas orifice.
A
IMPORTANT: Check that the orifice is properly installed inside
of the supply pipe.
6. Reinstall the spider guard, access cover, and wind baffle.
Change the Sear Burner Orifices
1. Remove the 2 screws securing the igniter and remove the
igniter from the side burner.
2. Remove the searing side burner screws. Set the screws and
cover aside.
3. Lift the searing side burner out of the grill.
Orifice
15

Publicidad

loading

Este manual también es adecuado para:

730-0709b ng