Metabo BS 18 LT Instrucciones De Manejo página 9

4. Figures
Illustrations are provided at the beginning of the
operating instructions.
Symbol explanation:
Movement direction
Slow
Fast
First gear
Second gear
Screws
Drill bit
Without torque limitation
Impact drilling
Torque
Nm
5. Overview
Fig. A
1 Keyless chuck
2 Sleeve (torque, drilling, impact drilling)*
3 Switch (1st/2nd gear)
4 Rotation selector switch (rotation setting,
transport lock) - both sides of the machine
5 Bit depot *
6 Belt hook *
7 Battery pack release button
8 Capacity indicator button
9 Capacity and signal indicator
10 Battery pack
11 LED lights
12 Trigger switch
*equipment-specific
6. Use
6.1 Battery pack, capacity and signal display
Fig. B
Charge the battery pack before use.
If performance diminishes, recharge the battery
pack.
The ideal storage temperature is between 10°C and
30°C.
6.2 Removing, replacing battery pack
Fig. C
6.3 Setting direction of rotation, transporting
safety device (switch-on lock)
6.4 Selecting gear stage
Do not set the switch (3) unless the motor has
stopped completely!
6.5
6.6
Switching on, speed: press the trigger (12). The
Switching off: release the trigger (12). Note: The
6.7
With a soft tool shank, retightening may be required
after a short period of operation.
Notes on machines with the designation SB...:
1. The ratchet sound which can possibly be heard
2. Clamping tool:
Cleaning: From time to time, hold the machine
6.8
Employ the same procedure when attaching the
chuck, except in reverse order.
6.9
To remove: Push the interlock ring forward (a),
advance and pull off the chuck (b).
To mount: Push the interlock ring forward and
move the chuck as far as the limit stop on the drill
spindle.
6.10 Attaching the belt hook (depending on
Attach the belt hook to the left (6), as shown.
Attach the bit depot to the right (5), as shown.
Fig. D
7.1
Fig. E
protection mode. A warning signal sounds (contin-
Setting torque limitation,
drilling, impact drilling
Switching on/off, setting speed
Fig. A
speed can be changed by pressing in the
trigger.
noise that the machine makes when it switches
off is due to the design (quick stop) and has no
influence on the function or the service life of
the machine.
Keyless chuck
after opening the drill chuck is functional and is
switched off by a reverse rotation of the sleeve.
Turn sleeve in direction "GRIP, ZU" until the
noticeable mechanical resistance has been
overcome.
Caution! The chuck is not yet fully tight-
ened! Keep turning the sleeve (it must "click"
when turning)) until it cannot be turned any
further - only now is the tool safely clamped.
vertically with the keyless chuck facing
downwards and turn the sleeve fully in direction
"GRIP, ZU" and then turn fully in direction
"AUF, RELEASE". The dust collected falls from
the keyless chuck.
Unscrewing chuck
Chuck with quick bit change system (for
BS 14.4 LT Quick, BS 18 LT Quick)
Fig. I
machine features)/bit depot (depending
on machine features)
7. Troubleshooting
The machine's multifunctional monitoring
system
If the machine switches off automatically, the
machine electronics have activated automatic
ENGLISH en
Fig. F
Fig. G
Fig. H
Fig. J
9