Stihl HT 100 Manual De Instrucciones página 41

File down the depth gauge until it is
N
level with the filing gauge.
Sharpening Tools (special accessories)
Chain pitch Round file ^
inch (mm) mm (inch)
1/4 P (6,35) 3,2 (1/8)
1/4 (6,35) 4,0 (5/32)
3/8 P (9,32) 4,0 (5/32)
0.325 (8,25) 4,8 (3/16)
3/8 (9,32) 5,2 (13/64)
1)
consisting of file holder with round file, flat file and filing gauge
HT 100, HT 101, HT 130, HT 131
File the top of the depth gauge
N
parallel to the stamped service
marking (see arrow) – but do not
lower the highest point of the depth
gauge in this process.
WARNING
The kickback tendency of the machine is
increased if the depth gauges are too
low.
Round file File holder
Part No. Part No.
5605 771 3206 5605 750 4300
5605 772 4006 5605 750 4327
5605 772 4006 5605 750 4327
5605 772 4806 5605 750 4328
5605 772 5206 5605 750 4329
Place the filing gauge on the chain –
N
the highest point of the depth gauge
must be level with the filing gauge.
After sharpening, clean the chain
N
thoroughly, remove filings or
grinding dust – lubricate the chain
thoroughly.
Before a long out-of-service period,
N
clean the chain and store it in a well-
oiled condition.
Filing gauge Flat file
Part No. Part No.
0000 893 4005 0814 252 3356
1110 893 4000 0814 252 3356
1110 893 4000 0814 252 3356
1110 893 4000 0814 252 3356
1110 893 4000 0814 252 3356
English
1)
Sharpening kit
Part No.
5605 007 1000
5605 007 1027
5605 007 1027
5605 007 1028
5605 007 1029
39