Cutting Attachment; Mounting The Bar And Chain - Stihl HT 100 Manual De Instrucciones

English

Cutting Attachment

A cutting attachment consists of the saw
chain, guide bar and chain sprocket.
The cutting attachment that comes
standard is designed to exactly match
the pole pruner.
1
a
The pitch (t) of the saw chain (1),
–
chain sprocket and the nose
sprocket of the Rollomatic guide bar
must match.
The drive link gauge (2) of the saw
–
chain (1) must match the groove
width of the guide bar (3).
If non-matching components are used,
the cutting attachment may be damaged
beyond repair after a short period of
operation.
16
Chain scabbard
2
Your pole pruner comes standard with a
chain scabbard that matches the cutting
attachment.
3
If you use guide bars of different lenghts
on the pole pruner, the length of the
chain scabbard must be matched to the
guide bar to reduce the risk of injury. It
should cover the full length of the guide
bar.
The length of the matching guide bars is
marked on the side of the chain
scabbard.

Mounting the Bar and Chain

Removing the chain sprocket cover
Unscrew the nut and remove the
N
cover.
1
2
Turn the screw (1)
N
counterclockwise until the tensioner
slide (2) butts against the left end of
the housing slot, then back it off 5
full turns.
HT 100, HT 101, HT 130, HT 131