Checking Chain Lubrication; Adjusting The Telescoping Shaft; Fitting The Harness - Stihl HT 100 Manual De Instrucciones

English

Checking Chain Lubrication

The saw chain must always throw off a
small amount of oil.
NOTICE
Never operate your saw without chain
lubrication. If the chain runs dry, the
whole cutting attachment will be
irretrievably damaged within a very short
time. Always check chain lubrication and
the oil level in the tank before starting
work.
Every new chain has to be broken in for
about 2 to 3 minutes.
After breaking in the chain, check chain
tension and adjust if necessary – see
"Checking Chain Tension".
24
Adjusting the Telescoping
Shaft
HT 101, HT 131 only
WARNING
Always shut off the engine and fit the
chain guard
Loosen the screw.
N
Adjust shaft to the required length.
N
Tighten down the screw firmly.
N

Fitting the Harness

The type and style of the harness
depend on the market.
Shoulder strap
2
Put on the shoulder strap (1).
N
Adjust the length of the strap.
N
With the power tool attached, the
N
carabiner (2) must be at about the
same height as your right hip.
HT 100, HT 101, HT 130, HT 131
1