Bosch 06019C3300 Manual Original página 25

– Insert the accessory into the holders provided for it: Suc-
tion tubes (35) into the holders (22), crevice nozzle (31)
into the holder (21), floor nozzle (34) into the holder
(24).
– Open the elastic bands of the vacuum hose holder (4)
and wrap the vacuum hose (27) around the top part of
the dust extractor in the holder (4).
Hook the elastic bands back in.
– Click the L-Boxx onto the holders (11).
– Store the dust extractor in a dry room and secure it so
that it cannot be used by unauthorised persons.
– Put the castor brake (17) down to hold the castors (18)
in place.
Problem
The suction turbine will not switch on. – Check the mains cable, mains plug, fuse, socket and fill level sensors (40).
The suction turbine switches off.
The suction turbine will not switch on
again after emptying the container.
The suction power is decreasing.
Dust is escaping when vacuuming
Automatic switch-off (wet extraction)
is not working.
Acoustic warning signal sounds.
Bosch Power Tools
Transport (see figure M)
– To transport the dust extractor, screw the sealing plug (2)
onto the hose adapter (3).
– Only ever carry the vacuum cleaner by the carrying handle
(10).
– Use the guide handle (12) to push the dust extractor or to
pull it up steps.
Rectifying faults
If a fault (e.g. a filter damage) occurs, the vacuum
u
cleaner must be switched off immediately. The fault
must be repaired before resuming operation.
Corrective measures
The mode selector switch (7) is set to "automatic start/stop".
– Set the mode selector switch (7) to the "vacuuming" symbol or switch on the
power tool plugged into the electric socket (5).
– Empty the container (1).
– Switch the dust extractor off and wait five seconds before switching it back on.
– Clean the fill level sensors (40) and the space between the fill level sensors (40)
using a brush.
– Remove any blockages from the vacuum nozzle, suction tube (35), vacuum hose
(27) or flat-pleated filter (30).
– Change the disposal bag (29) or dust bag.
– Make sure the filter cover (39) is engaged correctly.
– Place the top part of the dust extractor (13) on correctly and close the catches
(15).
– Change the flat-pleated filter (30).
– Check that the flat-pleated filter (30) has been fitted correctly.
– Change the flat-pleated filter (30).
– Clean the fill level sensors (40) and the space between the fill level sensors (40)
using a brush.
Automatic switch-off will not work in the presence of non-conductive liquids or foam-
ing.
– Check the fill level regularly.
Suction power setting too low.
– Set the suction power regulator (8) to a higher setting.
Hose diameter setting is wrong.
– Set the volume flow controller (6) to the correct vacuum hose diameter.
Vacuum hose (27) is blocked or twisted.
– Remove blockage or untwist hose.
Disposal bag/dust bag full.
– Change the disposal bag (29) or dust bag.
Flat-pleated filter (30) is dirty.
– Clean or change the flat-pleated filter if required.
The airflow supplied by the connected power tool is insufficient.
English | 25
1 609 92A 6R5 | (02.09.2021)