Publicidad
10
3 mm
2 x
English
Set the High Temperature Limit
Stop (optional)
Use a 3 mm Allen wrench to push the screw cover
into the handle.
Use the 3mm Allen wrench to loosen the handle
screw 2 complete revolutions.
Remove the handle.
Retrieve the screw cover.
Remove the flange.
Remove the high temperature limit stop.
Replace the high temperature limit stop so that the
pin on the cartridge is in the desired slot on the
limit stop.
Note: the temperatures given in the diagram
assume a water heater temperature of 140° F,
a cold water temperature of 50°F and a water
pressure of 45 PSI.
Replace the flange.
Replace the handle.
Tighten the handle screw.
Install the screw cover.
Publicidad
