EINHELL TC-ID 600 E Manual De Instrucciones Original página 29

Benefits:
•
The drill bit is easier to control when starting
the hole and will not slide away.
•
You avoid drilling messy holes (for example
in tiles).
6.3 Preselecting the speed (Fig. 7/Item 6)
•
The speed setting ring (6) enables you to
define the maximum speed. The ON/OFF
switch (5) can only be pressed to the defined
maximum speed setting.
•
Set the speed using the setting ring (6) on the
ON/OFF switch (5).
Do not attempt to make this setting whilst the
drill is in use.
6.4 Clockwise/Counter-clockwise switch
(Fig. 7/Item 7)
•
Change switch position only when the drill is
at a standstill!
•
Switch the direction of the hammer drill using
the clockwise/counter-clockwise switch (7):
Direction
Clockwise
(forwards and drill)
Counter-clockwise
(reverse)
6.5 Drill / hammer drill selector switch (Fig. 8/
Item 3)
Change switch position only when the drill is at a
standstill!
Drill
Drill / hammer drill selector switch (3) in the drill
position. (Position A)
Use for: Wood, metal, plastic
Hammer drill
Drill / hammer drill selector switch (3) in the ham-
mer drill position. (Position B)
Use for: Concrete, rock, masonry
6.6 Tips for working with your hammer drill
6.6.1 Drilling concrete and masonry
•
Switch the Drill/Hammer drill selector switch
(3) to position B (Hammer drill).
•
Always use carbide drill bits and a high speed
setting for drilling into masonry and concrete.
Anleitung_SA_TC_ID_600_E_SPK8.indb 29 Anleitung_SA_TC_ID_600_E_SPK8.indb 29
GB
6.6.2 Drilling steel
•
•
•
6.6.3 Inserting/ Removing screws
•
•
6.6.4 Starting holes
If you wish to drill a deep hole in a hard material
(such as steel), we recommend that you start the
hole with a smaller drill bit.
6.6.5 Drilling tiles
•
•
Switch position
Pushed to the right
Pushed to the left
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the authorized after-sales
service to avoid danger.
8. Cleaning, maintenance and
Danger!
Always pull out the mains power plug before
starting any cleaning work.
8.1 Cleaning
•
•
•
- 29 -
Switch the drill / hammer drill selector switch
(3) to position A (drill).
Always use HSS drill bits (HSS = high speed
steel) and a low speed setting for drilling
steel.
We recommend that you lubricate the hole
with a suitable cutting fluid to prevent unne-
cessary drill bit wear.
Switch the Drill/hammer drill selector switch
(3) to position A (drill)
Use a low speed setting
To start the hole, switch the drill / hammer drill
selector switch (3) to position A (drill).
Switch the drill / hammer drill selector switch
(3) to position B (hammer drill) as soon as the
drill bit has passed through the tiles.
ordering of spare parts
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
We recommend that you clean the device
immediately each time you have finished
using it.
Clean the equipment regularly with a moist
30.08.2021 12:45:01 30.08.2021 12:45:01