Celexon HomeCinema Plus Manual De Instrucciones página 33

CONTROL VIA THE TRIGGER
The built-in trigger function controls the screen depending on the power sta-
tus of components used with it. Connect the enclosed USB jack trigger cable
to the trigger-out port of your screen.
You can connect the projection screen to a USB output of your projector, pro-
vided that these outputs are switched off in standby. (Alternatively, you can
use any other device with a USB output, as long as it is switched on and off in
parallel with the projection.)
Alternatively, you can purchase an optional wireless trigger or a jack trigger
cable from celexon.
Optional jack trigger cable: Only possible if your projector is equipped with
a Trigger Out connector. The trigger function must be activated in the pro-
jector's menu and the projector should comply with the trigger standards of
5-12V DC and provide a complete shutdown of the voltage in standby.
Your screen will now automatically raise or lower according to the switching
status of your projector.
Please note: There are devices which do not stop the current at the trigger or
USB outputs in standby, the trigger function may not work in these cases.
CONTROL VIA THE REMOTE CONTROLS
The screen is supplied with one infrared and one radio remote control. Make
sure that any protective film has been removed from all transmitter and recei-
ver devices, the remote controls are charged (or batteries are inserted) and
the screen is connected to the power source.
USE OF THE RADIO REMOTE CONTROL (RF)
The use of a radio remote control is always recommended if there is a large di-
stance between the remote control and the screen, or objects obstruct the line
of sight between the remote control and the screen. The radio remote control
is already paired and can be can be used straight away.
12