Hitachi Koki WR 12DM2 Manual De Instrucciones página 12

English
ASSEMBLY AND OPERATION
APPLICATIONS
<WH12DM2>
Driving and removing of small screws, small bolts, etc.
<WR12DM2>
Tightening and loosening of all types of bolts and nuts, used for securing structural
items.
REMOVAL AND INSTALLATION METHOD OF BATTERY
Handle
Recharge-
able
battery
Fig. 3
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
12
Latch
Insert
Pull out
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
WARNING:
How to install the battery.
Align the battery with the groove in tool
handle and slip it into place.
Always insert it all the way until it locks in
place with a little click, If not, it may
accidentally fall out of the tool, causing injury
to you or someone around you. (Fig. 3)
How to remove the battery.
Withdraw battery from the tool handle
while pressing the latch on the side of the
battery. (Fig. 3)
Do not use the electrical cord if damaged. Have it
repaired immediately.