Descargar Imprimir esta página

Hitachi Koki WR 12DM2 Manual De Instrucciones página 15

Ocultar thumbs Ver también para WR 12DM2:

Publicidad

Idiomas disponibles

Idiomas disponibles

The battery will not be recharged. In such a case, let the battery cool before charging.
G
When the pilot lamp flikers rapidly in red (at 0.2–second intervals), check for and take
out any foreign objects in the charger's battery installation hole. If there are no foreign
objects, it is probable that the battery or charger is malfunctioning. Take it to your
authorized Service Center.
G
Since the built-in micro computer takes about 3 seconds to confirm that the battery
being charged with UC14YFA or UC14YF2 is taken out, wait for a minimum of 3 seconds
before reinserting it to continue charging. If the battery is reinserted within 3 seconds,
the battery may not be properly charged.
Regarding electric discharge in case of new batteries, etc.
As the internal chemical substance of new batteries and batteries that have not been
used for an extended period is not activated, the electric discharge might be low when
using them the first and second time. This is a temporary phenomenon, and normal
time required for recharging will be restored by recharging the batteries 2 – 3 times.
How to make the batteries perform longer.
(1) Recharge the batteries before they become completely exhausted.
When you feel that the power of the tool becomes weaker, stop using the tool and
recharge its battery. If you continue to use the tool and exhaust the electric current, the
battery may be damaged and its life will become shorter.
(2) Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after use. If such a battery is recharged
immediately after use, its internal chemical substance will deteriorate, and the battery
life will be shortened. Leave the battery and recharge it after it has cooled for a while.
BEFORE USE
Check the work area to make sure that it is clear of debris and clutter.
Clear the area of unnecessary personnel. Ensure that lighting and ventilation is adequate.
OPERATION
1. Using the light equipped hook
CAUTION:
G
Do not attach the tip tool to the tool main unit when carrying the tool main unit with
the light equipped hook suspended from a waist belt.
Such action could result in injury.
English
15

Publicidad

loading

Este manual también es adecuado para:

Wh 12dm2